Benchmaster MV-1 Mill

I’ve assembled the Benchmaster MV-1 Mill. Johanna got this tool for me for me back in November, but I have been focusing on other project in the shop and hadn’t gotten to it yet. Its sat in a big pile on the floor of the last two months.

 

 

 

 

 

 

 

I have the table resting on the mill in these shots, as I needed to do some adjusting with the set screws. You can also see that I’ve got a 1hp motor attached hooked up. I don’t know much about this motor, its been kicking around the shop for the last few years. It seems to work well for this setup.

Digging through the pill of tools that Johanna got me, I’ve sorted the mill and lathe tooling. Here are a few other things that I think belong to the mill.

 

 

 

 

One Reply to “Benchmaster MV-1 Mill”

Leave a Reply

Your email address will not be published. Required fields are marked *